INSTALLATION INSTRUCTIONS
TRU-FIT
DOOR & PANEL
FIGURE 9
FIGURE 10
STEP 10
Once Wall Channel (C) is attached, remove tape from Curb Channel
(D) and carefully slide directly out from under Wall Channel (C)
(See Figure 10)
STEP 11
Place Glass Blocks (Q) on base to protect edge of glass
panel while adjusting for size (See Figure 11B). Set Glass
Panel (P) on blocks and gently slide into Wall Channel (C).
Make sure panel is as far in to the Wall Channel (C) as pos
-
sible.
THE PURPOSE OF THIS STEP IS FOR SPAC-
ING ONLY. PANEL WILL BE REMOVED AGAIN, SO
DO NOT PERMANENTLY ATTACH.
Using several
pieces of tape, inside and outside, secure Glass Panel (P) to
wall for the time being. (See Figure 11A)
STEP 9
Put a small amount of silicone in each hole drilled. Place Plastic An-
chors for Channels (J), if needed, in holes gently tap with hammer until
anchor is flush. It might be necessary to use a razor knife to cut the
lip of the anchor off so it is completely flush with the wall. Be sure
not to hit the tile.
(See Figure 9)
Set Wall Channel (C) in place and make sure holes line up. Using #8
x 2” Wall Channel Screws (K) provided, attach Wall Channel (C) to
wall.
FIGURE 11A
FIGURE 11B
FIGURE 12
STEP 12
With all six Wall Jamb Screws (H) securely in place, apply bead of
silicone to the outside ribbed edge of Wall Jamb (A) running the entire
length of both sides. (See Figure 12)
V5_21_26