Scanreco G2 radio remote control system
40
HMF Technical Service Department
Rev.:
20-13
Control of ID coding
While the remote control cable is fitted, it is possible by means of the LED display of the radio
controller to check whether the ID coding has been accepted.
- If the LED display indicates "
2 -
", the radio controller and the remote control box are not ID
coded together.
- If the LED display indicates "
1 -
", the radio controller and the remote control box have been ID
coded together.
Reasons for errors when carrying out ID coding
If the ID coding has not been carried out/accepted it may be due to the following reasons:
- Pushing/holding the push button
ON
in step 8 has not begun within the 10 seconds after the
radio controller has started (step 7).
- Failure in the remote control cable or the plug. Check that it is possible to operate the crane
via cable remote control.
- There must not be a battery in the remote control box.
- Check that the red Power LED is lit during the entire procedure, i.e. until the buzzer has given
5 periodic signals (step 10).
- If the remote control box turns off after starting up or during the ID coding, it is due to an
internal error.
