−
16
−
ITEM
INJECTOR
BATTERY
ECO
POWER
A/F
KNOCK
IF BOOST
IF WATER
IF OIL_T
IF OIL_P
IF FUEL_P
IF EXT_T
DESCRIPTION
Injection Time
Battery Voltage
Real-Time Fuel Economy
Horsepower
A/F Value
Knocking Value
I/F Unit Boost
I/F Unit Water Temperature
I/F Unit Oil Temperature
I/F Unit Oil Pressure
I/F Unit Fuel Pressure
I/F Unit EGT
ITEM
SPEED
REV
WATER
IGN
CORRECT
LEARN
AIR
IN_TEMP
THROTTLE
IN_MANI
O2_VOLT
AIRFLOW
DESCRIPTION
Speed
Engine RPM
Water Temperature
Ignition Timing
A/F Correction Value
A/F Learning Value
Intake Air Volume
Intake Air Temperature
Throttle Position
Intake Manifold Pressure
O2 Voltage
Airflow Voltage
●
CAR WEIGHT (Vehicle weight)
This item is to enter the vehicle's weight. The set value range is from 10 to 2500kg in increments
of 10(kg). The value of the CAR WEIGHT must be the total number of the following:
①
The listed weight on the registration form.
②
Total weight of the driver/passengers at the time of calculation.
③
Weight of half the fuel tank representing total weight of fuel, oils, coolant, etc.
●
GAS COST (Fuel cost/USG)
This item is to enter the fuel cost. The set value range is from US$1.50 to 10.0 in increments
of US $0.01. COST in PAST mode is calculated from this value. The default value is US$1.50.
●
AUTO PAST (Automatic past function)
This item is to activate PAST mode (Channel A) automatically when the ignition is turned on.
AUTO PAST ON : Every time the ignition is turned on, Channel A of PAST mode will
automatically reset and starts new measurements.
AUTO PAST OFF: PAST mode is activated manually.
●
WARNING
This item is for the warning setting of each item under the following conditions:
TYPE (Item)
VALUE (Value)
DIRECTION (Range)
FUNCTION (Function)
: Select from 24 items.
: Set the warning value.
: Set the warning alarm to activate if the actual value exceeds or
falls short of set value.
: Set the warning alarm on or off.
●
ALL RESET
This function resets all entered values and settings back to default.
Select YES to initialize, NO to not initialize.
Advice
・
After initializing an ALL RESET, reapply initial settings in SET UP mode.
●
▼
(Go to the next page)
Press the ENTER button to go to the next page.
