--- 7 ---
6-2. Adjusting the Nailing Depth
The nailing depth is adjustable by turning the adjuster.
* Adjusting the adjuster (Fig. 5)
Fig. 5
Flush
Adjuster
Too deep
(Turn the
adjuster to the
shallow side.)
Too shallow
(Turn the
adjuster to the
deep side.)
Fig. 6
Carry out test driving. If the nails are too deep, turn the adjuster to the shallow side ( mark). If the nail
depth is too shallow, turn the adjuster to the deep side ( mark) (see Figs. 5 and 6). Depth is changed 1 mm
with each rotation of the adjuster.
Do not push up the pushing lever when turning the adjuster.
Place the lock lever in "FREE" position when driving nails.
6-3. Reduction of Exhaust Pressure with Muffler
Comparison of blowing dust (The area where concrete dust is blown is shown in black.)
Conditions: Nailed 5 times at 0.69 Mpa {7 kgf/cm2}. Used concrete dust.
NV 65AF3
Testing method
Actual example: A glove
was set to the air outlet
of the nailer to avoid
blowing dust (at the
interior finish work site)
Concrete dust is
placed on a board.
Concrete dust
Air outlet
Lock
Lock lever
FREE
SHALLOW
DEEP
C
S
70 mm
520 mm
660 mm
Summary of Contents for NV 65AF3
Page 45: ......