--- 36 ---
(b) Reassembly
Disassembly procedures should be followed in the reverse order. Note the following points.
Before reassembly, remove dust from the groove of the Nail Guide [105].
Fit the convex portions of Nail Stopper (A) [103] and Nail Stopper (B) [108] in the Nail Stopper Spring [104]
and the Stopper Spring [109] securely.
After reassembly, push Nail Stopper (A) [103] and Nail Stopper (B) [108] with fingers to check that they
return smoothly.
Mount the Nail Guide Shaft [102] facing its chamfered side upward.
Bend the tip of the Cover [111] and engage it with the convex portion of the Magazine [90] (Fig. 24).
11. INSPECTION AND CONFIRMATION AFTER REASSEMBLY
Check that Plunger (A) [73] moves smoothly.
Check that the Pushing Lever [35] slides smoothly.
Push Nail Stopper (A) [103] and Nail Stopper (B) [108] with fingers to check that they return securely.
Check that there is no air leakage from each part.
Check that the Model NV 65AF3 will not operate only by pulling the Trigger [45]. Also check that the Model
NV 65AF3 will not operate only by depressing the Pushing Lever [35].
Check that the Feed Piston [79] operates properly with an air pressure of 0.44 MPa {4.5 kgf/cm
2
}. (Open
the nail guide and perform idle driving.)
Check that there is no idle driving or bending nails when driving nails with an air pressure of 0.44 MPa
{4.5 kgf/cm
2
}.
(Note) Before conducting the driving test, turn the Adjuster [50] to the deepest position.
Check the tightening torque of each screw again.
Summary of Contents for NV 65AF3
Page 45: ......