--- 32 ---
Roll Pin D3 x 10 [79]
Pin [82]
Nail Feeder [83]
Ribbon Spring [85]
Feeder Spring [84]
Feeder Plate [81]
Fig.34
Pushing Lever Stopper [80]
Pin [82]
Apply grease to the contacting portions
of the Ribbon Spring [85] and the Nail
Feeder [83].
No protrusion
from the surface
Protrusion
Protrusion
(a) Disassembly
Remove the Pin [82] so that the Feeder Plate [81] and the Feeder Spring [84] can be removed.
Pull out the Roll Pins D3 x 10 [79] with a roll pin puller (3 mm (0.118") dia.). The Pushing Lever Stopper [80]
can be removed.
(b) Reassembly
Disassembly procedures should be followed in the reverse order. Note the following points.
After mounting the Feeder Plate [81] to the Nail Feeder [83], mount the Feeder Spring [84] aligning with the
protruded portion. Then insert the Pin [82] (Fig. 34).
Insert the Pushing Lever Stopper [80] into the Nail Feeder [83] and press-fit two Roll Pins D3 x 10 [79] to
secure them. Be careful not to protrude the Roll Pins D3 x 10 [79] from the surface (Fig. 34).
Apply grease to the contacting portions of the Ribbon Spring [85] and the Nail Feeder [83] (Fig. 34).
Summary of Contents for NR 65AK
Page 46: ...MEMO ...
Page 47: ......
