23
Selecting the Video Output
Mode
You must setup the audio output mode correctly, if not, you will
not get the video outputs. The default setting is CVBS.
•
CVBS: Composite video output and S-video output avail-
able. If the connected video output terminal is VIDEO OUT-
PUT or S-VIDEO OUTPUT on the rear panel, select this
item.
•
RGB: Color separate signal (Red, Green and Blue) outputs
are available. If the connected video output terminals are
SCART or R, G, B on the rear panel, select this item.
•
YUV: Video Chroma and Lum separate signal outputs are
available. If the connected video output terminals are Y, U, V
on the rear panel, select this item.
1
Press
SETUP
button to enter SETUP MENU. Use / to
select GENERAL SETUP (see page 22), and then press
ENTER
button.
2
Highlight VIDEO OUTPUT using / , then press
button
to go to the right option list. Select CVBS, RGB or YUV
using / , then press
ENTER
to confirm your selection.
3
Press
SETUP
again to exit menu.
Note:
•
Maybe there are not the terminals on your unit for Scart,
RGB and YUV outputs. These video output terminals are
used for options by manufacturer.
CVBS
RGB
YUV
Speakers Setup
Position
For the best possible surround sound all the speakers other
than the subwoofer should be the same distance from the
listening position.
However, this system allows you to place the center speaker
up to 1.6 meters closer (
B
) and the rear speakers up to 4.6
meters closer (
C
) to the listening position.
The front speakers can be placed from 1.0 to 15.0 meters
(
A
) from the listening position.
•
You can place the subwoofer at any position. If possible,
place the subwoofer near a corner to maximize the bass
response.
•
You can place the rear speakers either behind you or to the
side, depending on the shape of your room, etc.
When the rear speakers are placed to the side:
When the rear speakers are placed behind you:
45
o
20
o
90
o
A
A
B
C
C
45
o
20
o
90
o
A
A
B
C
C
