3-11
Manual Rev. 0.0 - March 2018
Section 3 - Installation (ATSC EC701HP Transmitter)
Figure 3-7
Front view of the Digital
Exciter - MOD GV 4992
1
2
6
7
8
3
4
5
9
10
11
12
1
2
6
7
8
3
4
5
9
10
11
12
1
2
6
7
8
3
4
5
9
10
11
12
3.5
Front Panel
3.5.1
Digital Exciter
The Digital Exciter's front panel contains the display,
the initialization LEDs and the keyboard.
IDENTIFICATION
1- Air vents.
2- Display - 2-line 40-column digital display through
which it is possible to view the navigation menu of
the Transmitter's management software.
3-
Displaces the cursor to the next left position.
4-
Displaces the cursor to the next lower
position, and increases or decreases the number of
digits.
5-
Displaces the cursor to the next right position
and shows the options.
6-
ETHERNET*
– RJ45 input connector for
monitoring and control via TCP-IP protocol.
7-
USB Port
– USB Device Port, used to GUI8001
communication with the software, allowing the user
perform mesuares on to the transmitter and make
corrections linear and non-linear.
8- USB Host Port, used for communication with
storage devices (USB Drives FAT32 up to 4GB)
allowing the user to import and export data to updade
Firmware and Drawer Import Static Tables for Modux.
9-
ESC
Returns to the previous menu.
10-
Displaces the cursor to the next upper
position, and increases or decreases the number of
digits.
11- ENTER key
Confirms the selection.
12- Initialization LEDs - The equipment is fitted with
LEDs to indicate energized equipment, loss of input
signal, and past and current alarms.
The transmitter's front panel provides access to the
following drawers: Digital Exciter and Power Drawer.
*Ethernet is a trademark of the Xerox Corporation.
