-18-
x
Reassembling of the housing (2)
(3) Mount Pushing Button (A)
[32]
in Housing (A). (B)Set
[29]
. Make sure that the U-shaped groove of
Pushing Button (A)
[32]
is correctly fitted onto the projection on the forward/reverse changeover lever of
DC-Speed Control Switch
[35]
.
(4) Mount Controller (B)
[36]
in Housing (A). (B)Set
[29]
while fitting the convex and concave features of
Controller (B)
[36]
into and onto the concave and convex features of Housing (A). (B)Set
[29]
,
respectively.
Install the wires connecting Controller (B)
[36]
and DC-Speed Control Switch
[35]
in the housing in
order of red and white wires. (See the figure below.)
(5) Fit housing units A and B of Housing (A). (B)Set
[29]
together, and then secure both units in place with
eight Tapping Screw (W/Flange) D3 X 16 (Black)
[38]
. (Be careful to prevent internal wires from being
caught between the housing units.)
(6) After completing step (5), turn Clutch Dial
[4]
to confirm that each setting indication "1" to drill mark
[
] can be aligned with the triangle mark on the housing. If the setting indications cannot be
aligned with the triangle mark, Clutch Dial
[4]
or Nut
[6]
is mounted incorrectly. In such case, correctly
mount the part concerned by referring to Item (2) in Section 2, "Reassembling the drive unit."
Check the clicking feel generated when you turn Clutch Dial
[4]
. If no clicking feel can be felt, the click
spring is mounted incorrectly. In such case, correctly mount the click spring by referring to Item (3) in
Section 2, "Reassembling the drive unit."
Controller (B)
[36]
Convex
feature
Concave
feature
Housing (A). (B)Set
[29]
(A)
Convex
feature
Concave
feature
Internal wire
