29
Remote control
Changing the frequency of remote control signal
The accessory remote control has the two choices on signal frequency Mode
1:NORMAL and Mode 2:HIGH. If the remote control does not function properly,
attempt to change the signal frequency.
In order to set the Mode, please keep pressing the combination of two buttons
listed below simultaneously for about 3 seconds.
(1) Set to Mode 1:NORMAL
MENU
and
MY BUTTON-4
buttons
(2) Set to Mode 2:HIGH
AV MUTE
and
MY BUTTON-1
buttons
Please remember that the REMOTE
FREQ. in the SERVICE item of the OPTION menu (
95
) of the projector to be
controlled should be set to the same mode as the remote control.
(1)
MY
BUTTON-4
button
MENU
button
(2)
MY
BUTTON-1
button
AV MUTE
button
Using the REMOTE ID function
Utilize this function to control specific projectors by the remote
control assigned the same ID number when you use multiple
projectors of the same type at the same time.
Assign an ID number to each projector before using the
REMOTE ID item in the SERVICE menu of the OPTION
menu (
95
). Press the
ID
button with the same ID number
as assigned to the projector you are going to control. The
ID
button selected will light for several seconds.
• Each time you press any button (except
ID
buttons), the
ID
button of
current selected ID number will light.
• To confirm the projector's current ID, press any
ID
button for 3 seconds. Its
number will be shown on each screen regardless of set ID of projector.
NOTE
ID
buttons
