Hitachi CMU LPQ520, User Manual

Page: 114 / 153

6 MAINTENANCE
6-13
Table 6-6 Error Message List (3/3)
No.
Error
code
Error message Error description
Fault
category Fault location
Termination Recovery
105 09xxxxxx User log04 Application software report Software Middleware
dependent
– –
106 09xxxxxx User log05 Application software report Software Middleware
dependent
– –
107 09xxxxxx User log06 Application software report Software Middleware
dependent
– –
108 09xxxxxx User log07 Application software report Software Middleware
dependent
– –
109 09xxxxxx User log08 Application software report Software Middleware
dependent
– –
110 09xxxxxx User log09 Application software report Software Middleware
dependent
– –
111 09xxxxxx User log10 Application software report Software Middleware
dependent
– –
112 09xxxxxx User log11 Application software report Software Middleware
dependent
– –
113 09xxxxxx User log12 Application software report Software Middleware
dependent
– –
114 09xxxxxx User log13 Application software report Software Middleware
dependent
– –
115 09xxxxxx User log14 Application software report Software Middleware
dependent
– –
116 09xxxxxx User log15 Application software report Software Middleware
dependent
– –
117 09xxxxxx User log16 Application software report Software Middleware
dependent
– –
118 07D10001 Module error (Battery Alarm)
The battery life (rough estimate) is
found exceeding one year. (*3)
Hardware Battery – Battery replacement
119 07D10002 Module error (Battery Not
Connected)
Battery not connected Hardware Battery – Connect the battery
cable to both modules.
120 07D10003 Module error (Battery Low)
“Battery low” condition detected Hardware Battery – Battery replacement
121 07D11001 Module error (PS off/Reset during
writing Flash memory)
A power-off condition or reset occurred
during a write to the flash memory.
－ －
– Load in the user
program again. (*3)
122 07D11002 Module error (Flash memory Erase
Error)
Clearing of the flash memory failed. Hardware CMU’s
internal flash
memory
– Hardware replacement
123 07D11003 Module error (Flash memory Write
Error)
A write to the flash memory failed. Hardware CMU’s
internal flash
memory
– Hardware replacement
124 07D11004 Module error (Flash memory Read
Error)
A read from the flash memory failed. Hardware CMU’s
internal flash
memory
– Hardware replacement
125 00000201 Message frame error
NX message frame abnormality
detected
Software NX header of
the NX
message frame
sent from the
communication
source
Abnormal
frame
discarded and
processing
continued
Check the NX
message frame's NX
header.
(*3) This error is logged when one year has elapsed since the initial connection of the LQZ500 module to the CMU module or its last
replacement (clearing the battery life time retained in the LQP525 or LQP527 module by operating the BATT.SET switch). In
addition to this error logging, the ALARM LED also starts blinking at that time. It should be noted that the above-mentioned
elapsed time does not reflect the actual remaining life of the LQZ500 module. This is because it is measured in the LQZ500
module by using its internal clock. Therefore, use the elapsed time only as a rough estimate.