2-1
StarBoard FX-E90W
How to use
English
2.
How to Use
2.1 How to Use Touch Mode
This section gives a basic description of how to use the board in touch mode.
2.1.1 Character Input
To input characters, use your finger or the stylus that was provided with the product.
- Using the stylus pen and Electronic pen
Use the pen on the board with your body kept sufficiently away, so that your palm and
elbow do not touch the board. If your hand or elbow touches the board, or you are within 1
cm of the board, it might cause an incorrect operation.
NOTICE
Do not scrape or strike the board surface by stylus pen.
Failure to comply may result in damage on the board surface.
Use an input tool with a thickness of least 7 mm.
When inputting to this product, use a tool that is at least 7 mm. If a pen or similar tool
with a thickness of less than 7 mm is used, the input will be unstable.
Also, do not use tools with a sharp tip, such as a ballpoint pen. If such a tool is used
incorrectly, it could damage the surface of the board.
Straight line might be blurred on the right side of input area.
About Drawing
