Hisun HS294-2, Owner'S/Operator'S Manual

Page: 47 / 68

Periodic Service
10-15
drain the oil into an oil pan.
3. After draining, reinstall the drain plug.
4. Fill with the new oil up to the upper notch
on the dipstick.
(See “LUBRICANTS, FUEL AND
COOLANT” in “MAINTENANCE” section.)
Oil capacity
[Filter exchanged] 1.8L (1.89U.S. qts.)
[Filter non-
exchanged]
1.6L (1.68U.S. qts.)
①
Oil Leve
②
Dipstick
■
Replacing Engine Oil Filter
CAUTION
To avoid personal injury:

Be sure to stop the engine before
changing the oil filter cartridge.

Allow engine to cool down sufficiently,
Oil can be hot and can burn.
1. Park the vehicle on a flat surface, remove
the seat and open the adjust hatch cover.
2. Remove the oil filter.
3. Put a film of clean engine oil on the rubber
seal of the new filter.
4. Tighten the filter quickly until it contacts
the mounting surface. Tighten filter by
hand an additional 1/2 turn only.
5. After the new filter has been replaced, the
engine oil normally decreases a little.
Make sure that the engine oil does not
leak through the seal and check the oil
level on the dipstick. Then replenish the
engine oil up to the prescribed level.
①
Bolt;
②
Cover
③
“O” seal ring;
④
Engine oil filter
IMPORANT:

To prevent serious damage to the engine,
use only a genuine filter.
■
Replacing Transmission Oil
CAUTION
To avoid personal injury:

Be sure to stop the engine before
changing oil.

Allow engine to cool down sufficiently,
oil can be hot and can burn.
1. Park the vehicle on a flat surface, raise
the cargo bed, and mount the safety
support.
2. Put a film of clean transmission oil;
3. Quickly tighten the filter until it contacts
the mounting surface, tighten it an