Hirschmann PRS 80, Operators & Service Manual

Page: 23 / 48

Service and Maintenance 23
6.3 Adding sensors
To add a new sensor,
Menu- SETUP/SENSORS/
This gives the sensor select/information screen. It shows the status of all hardware. In the example
below "NOT IN." means that none of the sensors are installed.
Sensor status screen.
Choose the sensor that you wish to install and follow the onscreen instructions, which will ask you to
remove the paper tap insulating the battery contact or installing the batteries into the transmitter. To do
this, remove the 4 screws from the transmitter housing and
remove the paper insulation tag that reads “REMOVE BEFORE
OPERATION” by holding the batteries in place with one hand and
removing the tag with the other or insert batteries, if not installed.
LOOSEN 4 SCREWS
© Hirschmann PRS80 REV. D 11/08/10 190183_D.DOC