Service / troubleshooting
© Hirschmann ECS, 2006; PRS 80 Wind Speed Rev.C 05/23/06
190184_C
13
7.3 No
Display
The only time you should need to open the console is when there is power to the console and the
display is blank. If you find it necessary to open the console, inspect the gasket for damages and
replace it if necessary, refer to Section 7.4
Troubleshooting Moisture
.
With power to the console you should see the following:
If the LED’s, are not working, replace the console. Note: the 2A fuse protects output relay in case
current over draw. The board is protected by a 0.5A resettable fuse.
7.4 Troubleshooting
Moisture
The receiver contains electronic components and has an IP65 protection rating. These electronic
components cannot be designed to withstand exposure to moisture over a longer period of time. If you
find water or moisture inside any of the housings, the source for the water ingress has to be detected
and corrected to ensure proper operation.
There are two major possibilities for the occurrence of excessive moisture inside an enclosure:
1) Water ingress; caused by a cracked or broken housing or lid, or a defective gasket.
2) Condensation
This outline gives instructions for detecting the cause for excessive moisture by using simple
troubleshooting methods and how to prevent the moisture ingress from happening again.
Indicator LED's
RED = POWER
FLASHING GREEN = OK
