Hioki 9605-01, Instruction Manual, Page: 69 / 100

63
────────────────────────────────────────────────────
8.3 Command Reference
────────────────────────────────────────────────────
Syntax
:MEASure:ITEM:HARMonic:SORT
<NR1>
<NR1> = 0 to 50
Example ":MEASure:ITEM:HARMonic:SORT 5"
Specify sorted results for the 1st
through 5th harmonics.
Function Specifies the highest harmonic order for
returning data in response to
"MEASure:HARMonic:SORT?". Items
to be output are according to
"MEASure:HARMonic:LIST?".
Note ・ An execution error results if the
numeric value specified is out of range.
・ Sorting is by level, and the content and
phase angle are output as degree data
for the respective level.
・
All harmonic orders from the 1st to the
specified order will be output.
Intermediate orders cannot be skipped.
・
The outputs items are always as
indicated by the
"MEASure:HARMonic:LIST?"
command.
Syntax
:MEASure:ITEM:HARMonic:SORT?
Response
syntax
":MEASure:ITEM:HARMonic:SORT
<data1>" <0-50> "
Example
Transmission
Response
":MEASure:ITEM:HARMonic:SORT?"
":MEASure:ITEM:HARMonic:SORT 5"
Function
Obtains the harmonic orders specified
by the
"MEASure:ITEM:HARMonic:SORT"
command.
Syntax
:MEASure:ITEM:HARMonic:WAVE
<NR1>,<NR1>
<NR1> = 0 to 63
Example ":MEASure:ITEM:HARMonic:WAVE
1,1"
As the default output items for the
normal measurement, +Upeak and -
Upeak are specified.
Function Sets the default items (waveform data)
to be transferred in the response
message to the
":MEASure:HARMonic?" query in the
default mode.
The item is set as shown below by
setting bits, to specify a single
numerical value.
Note
If the setting value is out of range, an
execution error occurs.
128 64 32 16 8 4 2 1
bit 7 bit 6 bit 5 bit 4 bit 3 bit 2 bit 1 bit 0
+Peak data1
- - HPIP3 HPIP2 HPIP1 HPUP3 HPUP2 HPUP1
-Peak data2
- - HMIP3 HMIP2 HMIP1 HMUP3 HMUP2 HMUP1
:MEASure:ITEM:HARMonic:SORT
Specifies the (highest) harmonic order of analysis during sorting.
:MEASure:ITEM:HARMonic:SORT?
Query the (highest) harmonic order of analysis when sorted.
MEASure:ITEM:HARMonic:WAVE
Sets the output item for the harmonic waveform data.