Hioki 9605-01, Instruction Manual, Page: 57 / 100

51
────────────────────────────────────────────────────
8.3 Command Reference
────────────────────────────────────────────────────
Syntax
:DATAout:ITEM:HARMonic:WAVE
<NR1>,..
(up to 2 items)
<NR1> = 0 to 63
Example ":DATAout:ITEM:HARMonic:WAVE
1,1"
As the default output items to the
floppy disk drive or printer for the
normal measurement, the waveforms of
+Upeak and -Upeak are specified.
Function Sets the output item for the harmonic
waveform data to FDD or printer.
Sets the waveform data.
Note
If the setting value is out of range, an
execution error occurs.
The item is set as shown below by
setting bits, to specify a single
numerical value.
128 64 32 16 8 4 2 1
bit 7 bit 6 bit 5 bit 4 bit 3 bit 2 bit 1 bit 0
+Peak data1
- - HPIP3 HPIP2 HPIP1 HPUP3 HPUP2 HPUP1
-Peak data2
- - HMIP3 HMIP2 HMIP1 HMUP3 HMUP2 HMUP1
Syntax
:DATAout:ITEM:HARMonic:WAVE?
Response
syntax
":DATAOUT:ITEM:HARMONIC:WAVE <0-
63>,<0-63>,<0-63>
"
Example
Transmission
Response
":DATAout:ITEM:HARMonic:WAVE?"
":DATAOUT:ITEM:HARMONIC:WAVE
1,1,1"
Function Queries the item set by the
":DATAout:ITEM:HARMonic:WAVE"
command.
Syntax
:DISPlay:HARMonic:GRAPh
<NR1>
<NR1> = 1, 2, 3
1: 1 item display
2: each items (3 graphs)
3: each mode (3 graphs)
(non): changing the screen
Example ":DISPlay:HARMonic:GRAPh 2"
Displays 3 graphs for each items.
Function Sets the items to be displayed on the
harmonic graph screen.
Note
Depending on wiring mode and unit, the
number of the graph to be displayed
varies.
:DATAout:ITEM:HARMonic:WAVE
Sets the output item for the harmonic peak data.
:DATAout:ITEM:HARMonic:WAVE?
Queries the output item for the harmonic peak data.
:DISPlay:HARMonic:GRAPh
Sets the items to be displayed on the harmonic graph screen.