72 Glossary
Servo Valve
A motorized butterfly valve for controlling flow
Set Key
This key is uses as an “Enter” key to select an item or procedure
Set-up
Calibration and setup procedure. Data is stored separately for the Spray and NH3
modes
Solenoid Valve
A 2-wire plunger type on/off valve for boom control
Speed Key
Will display speed in MPH
Spray Mode
Uses Spray Menu where Volume is in Gallons and Rate is in GPA
Target Rate
The application rate that you are trying to apply
Use Defaults
Erases all data and calibration numbers from memory and sets console back to fac-
tory default data
Variable Rate
The ability to change Application Rates on the go based on an application map.
Variable Rate Message An application rate received from the serial port. It must conform to one of the Hiniker
protocols.
Ver X.XX
Software Version Number displayed during power up.
Volume Key
Will display Total Volume in Gallons or Pounds of actual N counted since last
cleared
VPA
Volume Per Area such as GPA
DEFAULT VALUES
DESCRIPTION
SPRAY
NH3
COMMENTS
Rate 1
20.0 GPA
180.0 PPA
PPA = Actual Pounds of ‘N’ Per Acre
Rate 2
10.0 GPA
150.0 PPA
PPA = Actual Pounds of ‘N’ Per Acre
Left Boom
120 In
510 In
Center Boom
120 In
0 In
Right Boom
120 In
0 In
Servo Valve Response
6
6
Range Is 1 To 16
Flowmeter Cal. #
72.0 P/GAL
16.9 P/Lb
Distance Cal. #
2.00 P/FT
2.00 P/FT
Inline Sys.
Yes
Always Inline
Answer No For Bypass System
Remote Run/Hold
No
No
Horn
On
On
Minimum Flow
Off
Not Available
Off, On, Set, Adj.
Simulated Speed
Off
Off
Off, 1~9 MPH
Display Smoothing
1%
1%
1%~10%
Area Counter
0
0
Volume Counter
0
0
Mode
X
Summary of Contents for 8160
Page 2: ......
