Operation 15
To navigate the menu, change the “Value” or the
“answer” to the question, then press SET. The
new “Value” will be saved and you will advance
to the next menu item based on your answer.
NOTE: The default answers to the menu items
are set to allow you to press SET repeatedly
without changing any values or jumping to other
menus or routines. This is to prevent uninten-
tional changes and to allow for speedy access
to each item.
SELECTING OPERATING MODES
There are two separate modes for the 8160, the
Spray mode, and the NH3 mode. All calibration
numbers, all settings, and the Area and Volume
totals are stored separately for each mode. As
an example, if you perform the Distance Calibra-
tion while in the Spray mode you would need
to perform the Distance Calibration again after
switching to the NH3 mode.
HOW TO SELECT AND CHANGE OPERATING MODES
DISPLAY
COMMENTS and ACTIONS
Press and hold SET key for Two seconds to enter Set-Up
IS THIS A SPRAY
APPLICATION? Y
Or
IS THIS AN NH3
APPLICATION? Y
The Display will always show the current operating mode and “Y’ as the default
answer. Pressing SET will allow access to the menu for the current mode. To
change Operating Modes and access it’s Set-up Menu, press the key to
change the answer to “N” then press SET.
Pressing any key except SET, , or will provide a shortcut out of Setup and
return you to the current operating mode. For instructions on setting up an ap-
plication see Spray Mode Set-up or NH3 Mode Set-Up.
Summary of Contents for 8160
Page 2: ......
