24
English
2180561
*2180561*
17. Place the bottom carbon brush in the bottom cage.
Make sure that no wires are trapped. The carbon brushes and the wires have to be fitted exactly
as they were before replacement.
18. Place the casing in position and insert and tighten the casing screws.
Technical data
Torque (Casing)
1.35 Nm … 1.75 Nm
(1.00 ftlb
f
… 1.29 ftlb
f
)
7.4
Replacing the control switch
DANGER
Risk of injury!
Risk of electric shock.
▶
The power tool may be operated, serviced and repaired only by trained, authorized personnel. This
personnel must be specially informed of any possible hazards.
1. You will need the following items:
Materials
Control switch
2167705 (230 V)
2173716 (110 V)
2197122 (120~127 V)
Screwdriver (flat)
Screwdriver (combi Torx)
2. Disconnect the electric drill from the electricity supply.
3. Unscrew the casing screws and remove the casing.
4. Make a note of the positions of the plug connections.
5. Remove the supply cord. → page 21
6. Remove the carbon brushes. → page 22
7. Lift the motor out of the casing.
8. Use long-nose pliers to disconnect the 4 connectors from the stator.
9. Connect the 4 connectors of the new control switch to the stator.
10. Connect the cable from the capacitor to the stator (see illustration).
11. Position the motor and the control switch in the casing.
12. Insert the carbon brushes.
13. Fit the supply cord.
14. Position the wires as shown in the illustration.
Printed: 25.06.2019 | Doc-Nr: PUB / 5367014 / 000 / 06
