29
13 FCC statement (applicable in US)
13 FCC statement (applicable
in US)
- WARNING -
This equipment has been tested and has
been found to comply with the limits for a
class B digital device, pursuant to part 15
of the FCC rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residual installation.
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment on and off, the user
is encouraged to try to correct the
interference by one or more of the
following measures:
– Re-orient or re-locate the receiving
antenna.
– Increase the separation between the
equipment and receiver.
– Connect the equipment to an outlet on a
circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced TV /
radio technician for assistance.
Product information plate
CLASS II LASER PRODUCT
620-690nm/0.95mW max.
STARE INTO BEAM
LASER RADIATION - DO NOT
2
1/4 s
31
9549 C/11.04
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference received,
including interference that may cause undesired operation.
AVOID EXPOSURE
Laser radiation is emitted
from this aperture
Hilti = registered trademark of Hilti Corporation,
Schaan, LI
Type: PD 32
Made in
Germany
DIN EN 60825-1:2003
Printed: 07.07.2013 | Doc-Nr: PUB / 5070013 / 000 / 00
