20
8. Applications
8.1.2 Historical data memory
The range meter saves the last five
measurements or calculation including the
graphics. Always displays immediately after
the range meter is switched On with the
On/Off-key, before any function is activated
or before the “Measure” key is pressed,
these data can be recalled from the memo-
ry and displayed one by one using the
“Plus / Minus” key.
The symbol “Historical data mode active”
shows the data stored in the memory.
Example of the display of a saved volume
measurement:
8.2 Area measurement
Areas can be determined easily and quickly.
Press the "Area" function key. This switches
the laser beam on – ready for measuring.
The individual steps for determining an
area are supported by a corresponding
graphic display. To determine the floor
space of a room, for example, the following
procedure must be followed:
a
b
= a . b
1. At the start of the area function, the
laser beam is switched on.
2. Aim the range meter at the target.
3. Press the "Measure" key.
The room width will be measured
and shown.
4. After this, the graphic display will
automatically request measurement
of the room length.
5. Aim the range meter at the next
target to obtain the room length.
6. Press the "Measure" key.
The second distance will be measured,
the area immediately calculated and
the result shown in the result line.
Both distances required to calculate the
area appear in the intermediate result lines
and can be conveniently noted after the
measurements and the calculation.
- NOTE -
To determine another area, press the "Area"
function key again.
8.3 Volume measurement
Volumes can be determined in one
measuring operation.
Press the "Volume" function key. This
switches the laser beam on – ready for
measuring.
MEN
x
+
-
I
=
PD 25
Printed: 07.07.2013 | Doc-Nr: PUB / 5070013 / 000 / 00
