26
27
Selecting and setting the menu, continued
dELAY menu / self-timer
3. Operation
CONST menu / constants
Light menu / display illumination
Press the
button
to select menu mode.
Use the
,
buttons to select the
CONST menu.
Use the
,
buttons to enter the constant,
e.g. 0.234
The value entered can be recalled for use in
subsequent calculations (e.g. addition of a
constant to the measured value etc).
Press the
button
to select menu mode.
Use the
,
buttons to select the
light menu.
Use the
,
buttons to select the desired
illumination mode:
OFF
illumination off (power saving)
ON
illumination on constantly
AUTO
illumination on for 10 seconds after
pressing a button
Press the
button
to select menu mode.
Use the
,
buttons to select the
dELAY menu.
Use the
,
buttons to select the desired
delay time
(0 / 2 / 5 /10 / 20)
.
After pressing the “measure” button, the
measurement will be taken automatically when
the set time has elapsed (e.g. for taking
measurements from points where access is
difficult).
continued
MENU
CONST
0.234
MENU
Light
OFF
MENU
dELAY
0
3. Operation
Menu selection and setting
rEF menu / reference point
continued
Menu overview
Select menu mode by
pressing the
button.
Use the
,
buttons to select the
rEF menu.
MENU
rEF
Front edge of the tool
Tripod thread axis
Rear edge of the tool
(standard
setting)
Use the
,
buttons to select the desired
reference point:
Press the
button to exit menu mode.
rEF
CONSt
Light
dELAY
bEEP
UNIT
Select / exit menu mode
Scroll through the menus
Adjust menu values up / down
