![background image](http://html1.mh-extra.com/html/hilti/dx-460-gr/dx-460-gr_operating-instructions-manual_2136085008.webp)
3
en
3. Description
The tool is designed for professional use in fastening
applications where nails, threaded studs and compo site
fasteners are driven into concrete, steel and sand-lime
block masonry.
The tool works on the well-proven piston principle and
is therefore not related to high-velocity tools. The pis-
ton principle provides an optimum of working and fas-
tening safety. The tool works with cartridges of 6.8/11
caliber.
The piston is returned to the starting position and the
cartridges are fed to the firing chamber automatically
by gas pressure from the fired cartridge. This permits
fastenings to be made very quickly and economically
with nails and threaded studs.
As with all powder-actuated tools, the tool, fastener pro-
gram and cartridge program form a “technical unit”.
This means that optimal fastening with this system can
only be assured if the fasteners and cartridges are
specially manufactured for it, or products of equivalent
quality, are used. The fastening and application recom-
mendations given by Hilti are only applicable if these
conditions are observed.
The tool features 5-way safety – for the safety of the
operator and bystanders.
The piston principle
The energy from the propellant charge is transferred to
a piston, the accelerated mass of which drives the fastener
into the base material. As approximately 95 % of the
kinetic energy is absorbed by the piston, the fastener is
driven into the base material at much reduced velocity
(less than 100 m/sec.) in a controlled manner. The dri-
ving process ends when the piston reaches the end of
its travel. This makes dangerous through-shots virtual-
ly impossible when the tool is used correctly.
The drop-firing safety device
is the result of coupling
the firing mechanism with the cocking movement. This
prevents the Hilti DX tool from firing when it is dropped
onto a hard surface, no matter at which angle the impact
occurs.
The trigger safety device
ensures that the cartridge
cannot be fired simply by pulling the trigger only. The
tool can be fired only when pressed against the work
surface.
The contact pressure safety device
requires the tool
to be pressed against the work surface with a signifi-
4
3
2
1
Warning signs
General
warning
Warning:
hot surface
Obligation signs
Wear eye
protection
Wear a
safety helmet
Wear ear
protection
Symbols
Read the opera-
tion instructions
before use
2. General information
2.1 Signal words and their meaning
WARNING
The word WARNING is used to draw attention to a poten-
tially dangerous situation which could lead to severe
personal injury or death.
CAUTION
The word CAUTION is used to draw attention to a poten-
tially dangerous situation which could lead to minor per-
sonal injury or damage to the equipment or other prop-
erty.
2.2 Pictograms
The numbers refer to the illustrations. The illustra-
tions can be found on the fold-out cover pages. Keep
these pages open while you read the operating instruc-
tions.
In these operating instructions, the designation “the
tool” always refers to the DX 460 GR powder-actuated
tool.
Location of identification data on the tool
The type designation and the serial number are printed
on the type plate on the tool. Make a note of this infor-
mation in your operating instructions and always refer
to it when making an enquiry to your Hilti representa-
tive or service department.
Type:
DX460 GR
Serial no.:
Printed: 12.08.2013 | Doc-Nr: PUB / 5069839 / 000 / 02