Hilti DX 351 BT, Operating Instructions Manual, Page: 29 / 126

24
en
Cartridge falls out of the
cartridge strip
Cartridge strip melts
9. Troubleshooting
Cartridge doesn’t fire
Cartridge not transported
Cartridge strip cannot be removed
Fault Possible cause
■
Damaged cartridge strip
■
Carbon build-up
■
Tool damaged
■
Bad cartridge
■
Carbon build-up
-WARNING-
Never attempt to pry a cartridge
from the magazine strip or tool.
■
Tool is compressed too long
while fastening.
■
Fastening frequency is too high
■
Fastening frequency is too high
-WARNING-
Never attempt to pry a cartridge
from the magazine strip or tool.
Remedy
■
Clean the cartridge strip guide-
way (see 24)
If the problem persists:
■
Contact Hilti Repair Centre
■
Let the tool cool down and then
carefully try to remove the
cartridge strip (If the problem
persists: Contact Hilti Repair
Center)
■
Contact Hilti Repair Center
■
Manually advance the cartridge
strip one cartridge
■
If the problem occurs more often:
Clean the tool
(If the problem persists: Contact
Hilti Repair Center)
■
Compress the tool only briefly
while fastening.
■
Remove the cartridge strip
■
Disassemble the tool for fast
cooling and to avoid possible
damage
(If the tool cannot be disassem-
bled: Contact Hilti Repair Center)
■
Immediately discontinue using
the tool
■
Remove cartridge strip
■
Let the tool cool down
■
Clean the tool and remove loose
cartridge.
(If it is impossible to disassemble
the tool: Contact Hilti Repair
Center)
■
Tool overheated because of high
setting rate
■
Tool damaged
-WARNING-
Never attempt to pry a cartridge
from the magazine strip or tool.
Printed: 20.08.2013 | Doc-Nr: PUB / 5069824 / 000 / 02