![background image](http://html1.mh-extra.com/html/hilti/ds-ws10/ds-ws10_operating-instructions-manual_2136339049.webp)
8. Operation and the sawing procedure
Piston rod securing clamp
Return lock
Piston rod
Subsequently clamp the piston rod, set and tighten the
return lock
and then disengage the advance move-
ment locking lever
.
4
5
3
CAUTION
Always check that the advance cylinder is not under
pressure before releasing the advance movement lock-
ing lever.
The return lock
and piston rod securing clamp
can then be released and the piston rod
pushed in
by hand.
Steps before and after ending the sawing
operation
■
Before cutting right through, take care to ensure that
the wire, when released from the kerf, can be caught by
the guide pulleys mounted at the cutting line.
■
Reduce wire speed before cutting right through and
switch off the drive as soon as the object is cut through.
■
Switch off the drive unit and retract the piston (reverse
advance movement). Bring the pneumatic advance lever
to the neutral (middle) position and engage the carriage
locking lever.
■
Remove the sawing wire and disassemble the pulley
stands, drive unit and wire storage unit as far as neces-
sary by following the assembly instructions in the reverse
order.
8.6
49
3
4
1
Printed: 08.07.2013 | Doc-Nr: PUB / 5069736 / 000 / 01
Summary of Contents for DS WS10
