Hilti DS WS10, Operating Instructions Manual

Page: 30 / 68

When using scaffolds, ladders or platforms etc., check
that these of are undamaged, of a type that complies
with regulations, and that they are set up in accordance
with regulations.
The operator must ensure that no person is present in
the danger zone at any time during operation of the
saw. This also applies to areas not directly visible, e.g.
to the rear of the section of the structure being sawn.
If necessary, a sufficiently large area must be cordoned
off or security personnel posted accordingly.
Stay alert and carefully monitor the sawing operation,
the cooling water system and the area surrounding the
workplace. Do not operate the wire saw if your full con-
centration is not on the job!
No modifications may be made to the saw system equip-
ment. Alteration of the factory-set frequency convert-
er parameters (DS WS10-E) is not permissible.
Safety instructions for transporting the wire
saw
Avoid lifting and carrying heavy objects. Use suitable lift-
ing equipment and means of transport and share heavy
loads between several people.
Use the handles provided for transportation. Ensure that
the handles are always kept clean and free of grease.
Bear in mind that the machine could fall over. Stand it
only on a solid, level surface. Place additional supports
between the forward-facing pivoting pulleys and the sur-
face on which the saw is standing.
Make sure that the wire saw and its components cannot
move about or fall over during transportation.
Use only approved lifting equipment attached to the lift-
ing point provided when transporting the saw by crane.
Before transporting the saw, check that all removable
parts are securely fastened, that the drive unit is locked
in position and that the end stop is fitted. Never loiter
under loads suspended by crane.
5.7
5. Safety instructions
30
Printed: 08.07.2013 | Doc-Nr: PUB / 5069736 / 000 / 01