16
Setting up the wall saw system
Fastening the rail supports
CAUTION
■
Failure to observe the spacing shown may cause the
saw to wander off course and, in extreme situations,
may result in failure of the anchor fastenings.
■
Adequately dimensioned and correctly installed fas-
tenings are essential in order to ensure efficient and
safe operation of the equipment.
WARNING
Use an anchor suitable for the material on which you
are working and observe the anchor manufacturer’s
instructions.
NOTE
Hilti M12 metal expansion anchors are usually suitable
for fastening diamond core drilling equipment to uncracked
7.2
concrete. Under certain conditions it may be necessary
to use an alternative fastening method. Please contact
Hilti Technical Service if you have any questions about
secure fastening.
■
The construction materials and conditions encoun-
tered at the location where sawing is to be carried out
vary from site to site. Should you be unsure of the
strength of the supporting material and have doubts
about the solidity of the fastening obtained, please
contact Hilti Customer Service for technical advice.
NOTE
■
During installation, the leveling screws should not
project beyond the contact surface of the rail sup-
ports.
■
Use the DS-RFP rail support for angled and stepped
cuts.
Parts
No.
Designation
Contact surface
Anchor slot for fitting rail support
Leveling screws
Rail clamping plate
Rail support for regular cutting
Rail support for angled and stepped cutting
Rail clamping screw
Clamping screw for angle adjustment
Clamping plate for stepped cuts
Printed: 09.03.2015 | Doc-Nr: PUB / 5139344 / 000 / 01
