hilscher 7763.200, Manual

Page: 16 / 72

Descriptions and drawings 16/72
2.3.3 Host interface configuration jumper (X10)
These jumpers configure a few signals at the host interface according to
the connected extension modules and DPM modes.
X10 Pin Description
1 MMIO02 (netX 51)
2 MMIO05 (netX 51)
3 DPM_SIRQ# (X3 pin 4)
4 DPM_DIRQ# (X3 pin 11)
5 DPM_SIRQ# (netX 51)
6 DPM_DIRQ#/PI047 (netX 51)
7 RSTIN# (X3 pin 7)
8 DPM_A16 (netx 51)
9 RSTIN# (X3 pin 7)
10 RSTIN# (netx 51)
Table 12: Pin assignment X10
Position (23) in section Printed circuit board [
}
page 11].
Use the following setting if dual­port memory is connected:
X10 DPM Description
DPM_DIRQ# signal is connected to X3 pin 11
DPM_SIRQ# signal is connected to X3 pin 4
RSTIN# signal is connected to X3 pin 7
Table 13: X10 – Setting for Dual­Port Memory at host interface X3
Use the following setting if Extension bus is connected:
X10 EXT Description
If NXHX 6­RE or NXHX 52­RE Board is connected to the host interface
and used as extension bus!
MMIO02 signal is connected to X3 pin 4 (configure MMIO02 as
interrupt input for DPM_SIRQ#)
MMIO05 signal is connected to X3 pin 11 (configure MMIO05 as
interrupt input for DPM_DIRQ#)
DPM_A16 signal is connected to X3 pin 7 (256 KB address range at
HIF)
Table 14: X10 ­ Setting for Extension Bus at host interface X3
NXHX 51­ETM | Development Board
DOC120606HW06EN | Revision 6 | English | 2015­01 | Released | Public © Hilscher 2012 – 2015