hilscher 7763.200, Manual

Page: 11 / 72

Descriptions and drawings 11/72
2.2.2 Printed circuit board
Figure 2: NXHX51­ETM printed circuit board
No. in
figure Name Description For details see section
(1) X5 Fieldbus interface CH0
Fieldbus connector (X5 ­ 10­pin) [
}
page 28]
(2) X6 Fieldbus interface CH1
Fieldbus connector (X6 ­ 10­pin) [
}
page 28]
(3) V30 Communication status LED 0
(green / red)
LEDs [
}
page 32]
(4) V31 Communication status LED 1
(green / red)
(5) S1 Boot strap options Configuration Boot Strap Options ­ Switch (S1) [ }
page 12]
(6) X9 ETM­Interface netX 51 ETM connector (X9) [
}
page 30]
(7) X7 UART0 interface Serial connector (X7 ­ 10­pin) [
}
page 29]
(8) SW30 4 pol. DIL switch as general input MMIO general input ­ switch (S30) [
}
page 15]
(9) V15 LED yellow, MMIO27 as general output LEDs [
}
page 32]
(10) V14 LED yellow, MMIO26 as general output
(11) V13 LED yellow, MMIO25 as general output
(12) V12 LED yellow, MMIO24 as general output
(13) X4 microSD Card connector microSD card reader (X4) [ } page 27]
(14) X8 USB connector Typ B, HiTOP USB connector HITOP (X8) [ } page 29]
(15) X100 24 V power connector for board Power 24 V (X100) [ } page 31]
(16) X50 2 x RJ45 connector 2*RJ45 RT­Ethernet (X50) [ } page 31]
(17) ­ Matrix label Matrix label [ } page 67]
(18) V1 System status LED (yellow / green) LEDs [ } page 32]
(19) T1 Power on reset Reset [ } page 12]
NXHX 51­ETM | Development Board
DOC120606HW06EN | Revision 6 | English | 2015­01 | Released | Public © Hilscher 2012 – 2015