As the engine warms up, gradually turn the suction lever to the open
(horizontal) position.
3.3.2.
Starting a flooded engine
1.
Turn the ignition switch to the OFF position. Move the setting lever
to the fully open position (upper stop).
2.
Remove the spark plug boot, then unscrew the spark plug with a
special wrench. Keep turning counterclockwise.
3.
If the spark plug is dirty or is soaked with fuel, clean or replace it as
required.
4.
Remove excess fuel from the combustion chamber by pulling the
starter cord several times.
5.
Install the spark plug and tighten it with a spark plug wrench until
you feel a slight resistance. Reconnect the cord.
CAUTION! Incorrect installation of the spark plug may damage the engine!
6.
Start the engine in line with items 1-4 (3.3.1). Caution: Set the
suction lever horizontally, even when the engine is cold.
3.3.3.
Shutting down
1.
Release the throttle trigger or move the setting lever to the idle position
(lower stop). Let the engine idle for 2-3 minutes to cool down the
system.
2.
Move the ignition switch to the "OFF" position
3.3.4.
Directions for use
