DS-K1201 Fingerprint Card Reader
3
2.3
Wiring Cables
Purpose:
Wire the cables between the controller and the card reader, thus to establish the
communication between them.
Steps for RS-485 communication mode:
1.
Set the DIP switch for RS-485 address. For Details, refer to 2.1 Introduction for
DIP Switch.
2.
Wire the cable between the controller and the card reader as shown below.
Figure 2-3
Wiring for RS-485 Communication Mode
2.4
Installing Card Reader
Before you start:
Set the DIP switch. For details, refer to 2.1 Introduction for DIP Switch.
Steps:
1.
Fix the mounting plate on the wall with 2
provided screws.
Note:
Do not warp the mounting plate when
installing.
