12
Please note the different connections of JJ1 shown above.
For DC load, JJ1ca be safely used both in
NC
and
NO
methods, and it is recommended to use within the limit of
12V/1A. For external AC input, JJ1 must be open. The motherboard provides two jumpers, each corresponding to
one alarm output. By factory default, both of two jumpers are set to be connected.
2.3.3 Signal Line Connections
DS-6401HDI Decoder provides the green terminal plug for connecting signal lines. Follow the instructions shown
below:
1.
Disconnect the green terminal plug from the terminal socket on the device;
2.
Use the standard screwdriver to loosen the screws on the plug, and then insert signal lines to the plug and under
the spring washers, and finally tighten the screws.
3.
Connect the plug with signal lines to the corresponding green terminal socket.
Summary of Contents for DS-6401HDI Series
