Hikari HK2900, Instruction Manual

Page: 101 / 195

20
Remove tape ❶ fxing the lever sec on of safety switch ❷ .
1. When using the safety switch without removing tape ❶ , it is very dangerous since the
sewing
machine works even in the state that it is tilted.
2. In case error 302 occurs when the sewing machine works after setup, loosen the safety
switch
❷ ftting screw with a screwdriver, and lower the switch to the downside of the
sewing ma ‐
chine.
Tilt/raise the sewing machine head with both hands taking care not to allow your fngers to be caught
in the head. Turn OFF the power before starting the work so as to prevent accidents caused by abrupt
start of the sewing machine.
8. Tilting the sewing machine head
When tilting the sewing machine head, tilt the
head gently until it comes in contact with head support
rod
❶
.
1. before tilting the sewing machine head,
make sure that head support rod
❶
is
Attached to the machine table.
2. When raising the sewing machine head,
do not raise it while holding motor cover
❷
. It will be the cause of breakage of
motor cover
❷
.
3. Be sure to tilt the sewing machine head
on a flat place to prevent it from falling.