Hikari H9199, Instruction Manual Book And Parts Book

Page: 53 / 99

INSTRUCTION MANUAL
- 41 -
4-3Winding the lower thread
CAUTION
Do not touch any of the moving parts or press any objects against the machine while winding the lower
thread, as this may result in personal injury or damage to the machine.
1) Turn on the power switch.
2) Place the bobbin (1) onto the bobbin winder shaft(2).
3) Wind the thread several times around the bobbin(1) in the
direction indicated by the arrow.
4) Push the bobbin presser arm(3) toward the bobbin(1).
5) Raise the presser foot with the lifting lever.
6) Depress the treadle. Lower thread winging will then start.
7) Once winding of the lower thread is completed, the
bobbin presser arm(3) will return utomatically.
8) After the thread has been wound on, remove the
bobbin and cut the thread with the knife(4).
* Loosen the screw(5) and move the bobbin presser(6) to
adjust the amount of thread wound onto the bobbin.
NOTE
：
The amount of thread wound onto the bobbin should be a
maximum of 80% of the bobbin apacity.
4-4 Installing the bobbin case
CAUTION
Turn off the power switch before installing the bobbin case.
The machine may operate if the treadle is depressed by mistake, which could result in injury.
1) Turn the machine pulley to raise the needle
until it is above the needle plate.
2) While holding the bobbin so that the thread
winds to the right, insert the bobbin into the
bobbin case.
3) Pass the thread through the slot(1)and under the
tension spring(2), and then pull it out from the
thread guide(3) .
4) Check that the bobbin turns clockwise when the
thread is pulled.
5) Hold the latch(4), on the bobbin case and insert
the bobbin case into the rotary hook.