P l e a s e G i v e P a r t N o . , D e s c r i p t i o n a n d U n i t S e r i a l N o .
HIGHWAY EQUIPMENT COMPANY
26
89008-A
Page Rev. A
PROGRAMMING A JOB CONTINUED
Spinner Speed
Set to the target spinner speed required to achieve the desired spread width. New Leader recommends
pan testing every new product to determine the settings necessary for a good spread pattern. Consult
your spreader manual for instructions on pan testing.
The Mark V will sound an alarm when the spinner speed is 50 or more rpm above or below this setting.
Fan Frame Setting
Set to record the correct fan frame setting. New Leader recommends pan testing every new product to
determine the settings necessary for a good spread pattern. Consult your spreader manuals for
instructions on pan testing.
Calibrated CFR
This value defaults to the theoretical CFR entered in the machine setting (see machine setup section of
this manual). All products have unique flow characteristics that can vary the rate of actual product
conveyed through any given feedgate opening. The Calibrated CFR allows the user to fine tune this
value for any job. To insure the greatest accuracy possible, New Leader recommends a static test to
determine the calibrated CFR. See Appendix X for the recommended procedure.
After testing, set to the recorded CFR.
The actual fan frame setting must match the Mark V active job to assure
consistent results!
IMPORTANT!
Summary of Contents for New Leader MARK V DGPS-Ready
Page 2: ......