Page 14/34
Mark the position of the fan mounting
latches on the large end of the PVC duct
and cut them out (~2cm deep). Install the
fan in the fuselage. Slide the duct from the
rear into the fuselage. Fold it as shown to
fit the large end in.
Once inside, slide the intake end over the
fan unit. Mark the excess ducting sticking
out of the rear. Remove the duct and trim
the end to shape.
Prepare the elevator. Locate the CA hinge
slots in the elevator fin. Trial fit the
elevator rudder. If necessary, carefully
lengthen the slots to reach a perfect fit
between fin and rudder. Remove the rudder
and glue the CA hinges into the fin with
thin CA Glue.
Once cured, slot in the elevator rudder and
apply thin CA to glue it in place
