Page 7/34
Next the aileron can be installed. Locate
the CA hinge slots for each aileron. Trial fit
the aileron. If necessary, carefully lengthen
the slots to reach a perfect fit between
aileron and wing. Remove the aileron and
glue the CA hinges into the wing with thin
CA Glue. Once cured slot in the aileron
and apply thin CA to glue it in place.
Attach the supplied clevis (or use your
own) to the push rod. Use some masking
tape to stick the pushrod to the wing. The
pushrod should run parallel to the servo
centerline and touch the servo horn as
shown. A Z-Bend will later be used to
secure the rod to the servo. Move the
rudder horn so that it lines up with the
clevis. The holes in the rudder horn should
be directly above the pivot line between
aileron and wing.
Mark the rudder horn position and drill the
holes for the mounting screws. Fix the horn
in place. Enlarge the hole of the servo arm
with a suitable drill to the size of the
pushrod.
Center the servo again with your radio and
measure the length between horn and servo
in neutral position. Make a z-bend and
install the pushrod. Cover the servo and
cutout with a piece of the supplied iron on
film.
