5. Cleaning and Maintenance
Inspect the pool bottom robotic vacuum cleaner PEPS every week and replace
damaged or worn components.
The following tasks must be performed during weekly inspections:
ATTENTION!
Any manipulation on the robot PEPS necessitates the fact that
the robot is completely disconnected from the power supply.
- Put the main switch in position 0, disconnect the mains plug and put on protective
gloves.
- Clean the filter systematically after each use. In addition, check that the brushes and
belts are not blocked by any chewing gums, bandages, twine, twigs or other objects
that may interfere with the operation of the pool bottom robotic vacuum cleaner PEPS.
- Turn the robot over. Check the following points:
• Clean the body, chassis and filter column. The accumulation of sands, leaves and other
objects in interstices can affect performance.
• Make sure the check valve is not distorted and that it closes well in the down position.
Do not hesitate to replace it if it does not close properly at the water outlet.
• Check that all turbine blades of the robot are intact. Also check that the impeller
blades of the pump move freely.
A - Cleaning of filter
IMPORTANT!
You must clean your filtration in the end of each cycle of your
robot.
Do not exceed the capacity of the filter bag.
The robot should be disconnected from the power supply.
• Turn off the robot and disconnect the control box from the sector.
• Take the robot out of the water and place it on the trolley.
• The impurities have been trapped in the bag, just loosen the drawstring closure at the
bottom of the filter to disconnect it from the robot and access the impurities.
www.myhexagone.com • [email protected] • Tél. +33 1 34 34 11 55
14
