Hettich EBA 200, Repair Instructions

Page: 22 / 66

22/65
7.2.2 Acoustic signal
The acoustic signal sounds:
•
after a malfunction occurs in a 2-second interval.
•
after ending the centrifugation run and the rotor is at a standstill in a 30-second interval.
The acoustic signal is ended by pressing any key.
If the rotor is at a standstill, the acoustic signal can be set as follows:
The procedure can be aborted at any time by pressing the
STOP
OPEN
key. In this case, the settings are not stored.
SELECT
•
Press and hold the button for eight
seconds.
t/min:s RPM >RCF<
↓
SELECT
•
Press the key until the following is
displayed.
t/min:s RPM >RCF<
↓
START
PULSE
•
Press the key.
End beep : Acoustic signal after ending
the centrifugation run.
off : Signal deactivated.
on : Signal activated.
t/min:s RPM >RCF< t/min:s RPM >RCF<
↓
t
•
Set off or on with the keys.
t/min:s RPM >RCF< t/min:s RPM >RCF<
↓
SELECT
•
Press the key.
Error beep : Acoustic signal after a
malfunction occurs.
off : Signal deactivated.
on : Signal activated.
t/min:s RPM >RCF< t/min:s RPM >RCF<
↓
t
•
Set off or on with the keys.
t/min:s RPM >RCF< t/min:s RPM >RCF<
↓
SELECT
•
Press the key.
Beep volume : Volume of the acoustic
signal.
min : soft
mid : medium
max : loud
t/min:s RPM >RCF<
t/min:s RPM >RCF<
t/min:s RPM >RCF<
↓
t
•
Set min , mid , or max with the keys.
t/min:s RPM >RCF<
t/min:s RPM >RCF<
t/min:s RPM >RCF<
↓
Continued on next page