Hettich CADRO, Technical Information

Page: 43 / 47

44 | 45
CLICK !
1
3
4
2
CADRO Glass display case.
Lighting profiles.
By using the lighting clip-on profiles, angle profiles can be transformed
into lighting strips which discreetly and effectively illuminate your
exhibits. Due to the film-coated lighting clip-on profiles, the light only
penetrates the inner edge of the profile frame and thus, illuminates the
interior of the display case.
The 1-sided clip-on profile, order no. 9 303 924, is used to create a
closed profile side, e.g. for door surfaces.
PLEASE NOTE:
We recommend a detailed lighting planning in advance for your
display case. For this purpose, see also chapter CADRO Lighting |
planning on page 26.
Assembly.
At first, insert the glass panels and fix them with the corresponding
plastic clip-on profiles where no illumination is needed and no cables
need to be installed according to the planning
(see also page 34 | 35) .
Attachment of the LED lighting strips.
1
Now, the self-adhesive face of the angle profile for
LED strips are
attached on the beveled sur-glass panel , order no. 9 303 912 / 9 303 913.
Maximum width of the LED strips 6 mm.
2
Now, the LEDs are being covered by clipping on the lighting clip-on
profiles. At the same time, they help to fix the glass panes securely within
the frame.
Laying of the cables.
3
The cables are now guided towards the connector with cable exit (see
also page 29) . Afterwards, the glass panels are fixed with the correspon-
ding clip-on profiles. Thus, the cables are covered and invisibly hidden
within the frame.
For the connection to a low-voltage transformer, a plug is finally moun-
ted at the end of each pair of cables.
Lighting
clip-on profile
83160.****
Clip-on profile
83070.****
LED strip
Angle
profile
for glass
panels
9 303 912 /
9 303 913
Plug assembly.
4
For this purpose, the ends of the cables, which are already fitted with
sleves are connected to the Mini AMP plug 45074.****. Please observe
the black/white marking of the cable and the position of the plug
(see
figure on the right) . After the automatic locking, the plug and the cable
are permanently connected to each other. In case of a faulty assembly of
the plug, the cable can only be released by pressing on the locking device
of the plug.
Power supply.
Now, the connection can be made to a commercially available trans-
former or – even more convenient – to our power distribution system
CONEXIS.
(See page 29.)
Mini AMP plug
45074.****
13,5
18
13,5
13,5
Lighting
clip-on profile
1-sided
9 303 924
Lighting
clip-on profile
2-sided
9 303 925
42 | 43