2
Installation and Operating Instructions for Heta SL800 Aqua stove Pevex1018/AH/ver1:Jan 2013
Congratulations on your new stove.
We are sure that you will be happy
with your investment, especially if you
follow the advice and instructions we
have put together in these operating
instructions.
The Scan-line 800 Aqua have been
approved according to the EN 13240,
NS 3058/3059, 15a B-VG Defra ap-
proved for use in smoke control areas
throughout the UK.
Approval means that consumers can
be sure, that the stove meets a range
IMPORTANT
1. Make sure there is adequate pro-
vision to sweep the chimney.
2. Make sure there is adequate ven-
tilation to the room.
3. Please note that any extraction
fans operating in the same room
as the wood-burning stove can
reduce the chimney draft – which
may have an adverse effect on
stove combustion properties. In
addition, this may cause smoke to
be emitted from the stove when
the firing door is opened.
4. It must not be possible to cover
any air vents.
The floor
It is essential to ensure that the floor
surface can actually bear the weight
of the stove and a top-mounted steel
chimney, if applicable. The stove must
stand on a nonflammable surface
such as a steel floor plate or a brick
or tile floor. The size of the nonflam-
mable surface used to cover the floor
area must match national and local
regulations.
The chimney connection
The chimney opening must follow
national and local regulations. Howe-
ver, the area of the opening should
of specifications and requirements
intended to ensure that the materi-
als used are of good quality, that the
stove does not adversely affect the
environment, and hat it is economical
to use.
With your new stove you should have
received the following:
a. Operating instructions
b. A stove glove
Safety clearances
Stoves must always be installed in line
with national and, if applicable, local
regulations. It is important to abide by
local regulations regarding setting up
chimneys and connection to same.
Therefore, always consult your local
chimney sweep before installation, as
you are personally responsible for en-
suring that the applicable regulations
have been met.
Distance regulations
A difference applies to installation
next to flammable and non-flammable
walls. If the wall is made of non-
flammable material the stove can, in
principle, be placed flush against it.
However, we recommend leaving a
gap of at least 5 cm to facilitate clea-
ning behind the stove.
The minimum
distances to flammable material are
stated on the boiler plate and are
listed in the table on page 8.
Warning
A stove gets hot. (In excess
of 90 degrees) Take care
to ensure that children can
not come into contact with
it. Combustible materials should
not be stored in the compartment
below the ashpan.
INSTALLATION INSTRUCTIONS
