Herutu TW-800 Series, Operation Manual

Page: 26 / 33

TW-800
24
■ Before thinking failure
TW-800(Transmitter)
Phenomenon A cause and measure
No transmitting
(Not lighting LED Red or Green)
Battery level is low.
→ Please change a new battery (CR2032).
Limit switch is separated from transmitter.
→ Please check that the connector and limit switch connector
of a transmitter circuit board have connected firmly.
Limit switch is not hit.
→ Please adjust the location of limit switch. Please check that
limit switch hits.
Flashing RED LED 3 times.
It has not done
“
Pairing
”
(No registration)
→ Please do “Pairing” with receiver. Ref P14
Flashing RED LED 10 times
Receiver power is off.
→ Please check that receiver power is ON.
Communication distance is too far.
→ It is over the distance of this machine which can be
communicated.
The installation situation of receiver
’
s antenna is not good.
→ Please check that the antenna situation of receiver will be
good. Depending on the situation, please consider to use the
external antenna. Ref P3
It is impossible to communicate by outside cause.
→ Please check that there are productions uses 2.4GHz radio
wave. Please inform us with detail situations.
Flashing GREEN LED 3 times
Receiver is busy situation.
→ Receiver situation is within relay output time or double count
protecting time. Please check the setting of receiver. Ref 15
Lighting RED LED after transmitting
Battery level is low.
→ Please change a new battery(CR2032).
Impossible do
“
Pairing
”
Receiver is not
“
Pairing mode
”
.
→ Please made into “Pairing mode”. Please push the pairing
switch of a transmitter 3 seconds or more. Ref14