Hermann Bock practico ultra low 9.5/80, Installation And User Manual, Page: 28 / 40

28
5.4 Change of location
If the bed must be moved to another location, please follow these safety instructions:
– Lower the surface with key
(5)
of the hand control.
– Before proceeding with the health care bed pull the mains plug and attach with
the end panel to secure the power cable against falling and being crushed by
anything. Make sure that the cable is not dragged over the floor.
– Before inserted the mains plug again, inspect the power cable visually for me-
chanical damage (dents and kinks, abrasions and bare wires).
– Place the power cable in a way that it will not be rolled over or strained during
the operation of the bed or could be damaged when inserting the mains plug
again.
– Carry out the rest function as described on page 15.
5.5 Transport, storage and operating conditions
Transport and storage Operation
Temperature 0°C to +40°C 10°C to +40°C
Relative humidity 20% to 80% 20% to 70%
Air pressure 800hPa to 1060hPA
5.6 Function notes
To keep the bed in one location, lock the castor brakes on the chassis. To accomplish
this, use your foot to move the locking lever on each castor downwards. Make sure that
the castors are parallel to the longitudinal axis of the bed. This is important in the
Trendelenburg and the Anti-Trendelenburg position but also in the comfort seat posi-
tion. (Here, the brakes on one end panel must be unlocked.)
If necessary, pull the integrated side rails up until they lock into place. With different
mattress thicknesses, the minimum height must not be below 22 cm, taken from the
upper edge of the side rail above the mattress excluding any compression. (Further-
more, use a third detachable rail.)
5.7 Disposal
Each of the components made of plastic, metal and wood are recyclable and can be
disposed/recycled in compliance with the relevant legal provisions. Please note that
electric adjustable health care beds or nursing beds are considered commercially used
electronic scrap according to the WEEE-EC directive 2012/19/EC (b2b). All replaced elec-
trical and electronic components of the electrical adjustment system must be disposed