herdstar BinTrac Breeder Control, Operation Manual

Page: 27 / 52

Operation Manual
Version 2.0
27
Part Number MAN-000009
Setup Parameters
Follow the system wiring diagram (
Page 36 ) to aid in the installation process, including supplied relays and switches.
Once installation is completed, both the MASTER and the REMOTE Breeder control units must be programmed as
summarized below:
1. MASTER Breeder Control console controls the rooster unload batching withdrawal auger ( steps 1 through
19 ).
Access SETUP mode and configure the following:
•
Enable Peripherals (RUN LED) under the SETUP menu
•
Validate that the Batch type is set to Unload Batching
•
Set an L.C.CAP value that matches the total capacity of all load cells
•
Set a FuLL value that matches the maximum capacity of the weigh bin
•
Set the Hour time parameter (default is CST Zone)
2. REMOTE Breeder Console controls the hen unload batching withdrawal auger ( steps 20 through 27 ).
Access SETUP mode and configure/verify the following:
•
Validate Remote Display feature is enabled (GROSS WEIGHT LED solid on) under the SETUP
menu, as this feature will be automatically set once the unit is connected properly to the Master
Breeder unit
•
Verify that the batch type is set to Unload Batching
•
Validate that the L.C.CAP value matches what was entered on the MASTER display
System Settings in Setup Mode - MASTER
The SETUP mode is used to configure the one-time system setup settings for the appropriate configuration. The
following SETUP parameters MUST be correctly configured on the MASTER Breeder console to ensure proper
operation and weighing:
•
SETUP
•
BATCH
•
L.C.CAP
•
FULL
•
ZERO
•
HOUR
NOTE : When first powering on the unit
.
will be displayed, simply as a reminder that the load cell
capacity for the system must be entered in the SETUP menu to ensure proper weighing calibration.
NOTE : If there is no activity for a period of time while in SETUP mode, the system will exit and return to the Weight
Display mode.