MY21H01 - 32_1.0_30.07.2020
72
Troubleshooting, fault clearance and repair
9
Troubleshooting, fault clearance
and repair
9.1
Troubleshooting and fault
clearance
The components of the drive system are checked
constantly and automatically. If an error is
detected, an error message appears on the
display
. The drive may be shut off automatically,
depending on the type of error.
9.1.1
The drive system or display do not
start up
If the display and/or the drive system do not start up,
proceed as follows:
1
Check whether the battery is switched on. If
not, start the battery.
Contact specialist dealer if the battery level
indicator LEDs do not light up.
2
If the LEDs on the battery level indicator light
up, but the drive system does not start up,
remove the battery.
3
Insert the battery.
4
Start the drive system.
5
If the drive system does not start up, remove
the battery.
6
Clean all the contacts with a soft cloth.
7
Insert the battery.
8
Start the drive system.
9
If the drive system does not start up, remove
the battery.
10
Fully charge the battery.
11
Insert the battery.
12
Start the drive system.
13
If the drive system does not start up, remove
the display.
14
Fasten the display.
15
Start the drive system.
16
Contact your specialist dealer if the drive
system does not start up.
9.1.2
Error message
If an error message is displayed, run through the
following actions:
1
Make a note of the system message. There is
a table containing all system messages in
Section
2
Shut off and re-start the drive system.
3
If the system message is still displayed,
remove the battery and then re-insert.
4
Re-start the drive system.
5
If the system message is still displayed,
contact your specialist dealer.
Summary of Contents for Rob Family F360
