User manual Power Max L
50
HENSEL-VISIT GmbH & Co. KG
In this mode, the modeling light is set to 100W and the „Flash
Check“ function, which turns off the modeling light after flash-
ing and turns it back on as soon as the unit has recharged and
is ready to flash again, is activated.
Â
Connect the Expert D compact flash unit to one of the pow
-
er jacks on the
Power Max L
and switch the
Power Max L
on via the power switch
1
.
Â
Switch on the Expert D and press its SLAVE button for at
least 3 seconds: the flash unit now switches to the Power
Max mode which is then confirmed by a beep tone. The
selected output and „bat. “ blink alternately in the perfor
-
mance display to indicate the activated Power Max mode.
Additionally, the LED „FULL“ blinks on the flash unit indi
-
cating that the modeling light is dimmed to a fixed, non-
proportional 100W.
Â
After connecting and switching the first Expert D, you can
add – if needed – a second unit and also switch it to the
Power Max mode as indicated above.
The Expert D flash units stay in this mode once it is activated,
even after they are switched off. No damage occurs if the Expert
D are operated on a normal power supply when in Power Max
mode. To return to a full modeling light, the SLAVE button must
be pressed again for 3 seconds – the Power Max mode is deac
-
tivated.
ATTENTION!
Expert D flash units prior to serial number
1303H0030101340
(Ex
-
pert D 500) or
1303H0030100461
(Expert D 1000) do not function
in connection with the Power Max L and need a new operating
software.
Please contact your Hensel service at the Wuerzburg headquar
-
ters and have the update done there.
NOTE: We recommend turning off the modeling light when
using Expert D flash units connected to the
Power Max L
to
achieve highest flash capacity.