Henny Penny Wendy's Evolution Elite EEG-251, Operator'S Manual

Page: 79 / 90

Level
2
Programming
65
Menu Step Description
SP-21 Auto-Lift
Enabled Press and release the right arrow until “SP-21 AUTOLIFT EN-
ABLED?” flashes in the left display. Press the up or down arrow to
choose “YES LIFT” or “NO LIFT”. If fryer is fitted with the auto-lift op-
tion, SP-21 must be set to “YES LIFT”, otherwise, set SP-21 to “NO
LIFT”.
SP-22 Bulk Oil
Supply Press and release the right arrow until “SP-22 BULK OIL SUPPLY?”
flashes in the left display. Press the up or down arrow to choose “YES
SUPL” or “NO SUPL”. Set to “YES” if the oil is pumped into the vat
from an outside oil reservoir. Otherwise, set SP-22 to “NO”.
SP-23 Bulk Oil
Disposal Press and release the right arrow until “SP-23 BULK OIL DISPOSE?”
flashes in the left display. Press the up or down arrow to choose “YES
DISP” or “NO DISP”. Set to “YES DISP” if the oil is pumped from the
vats to an outside oil reservoir when discarding the oil. Otherwise, set
SP-23 to “NO DISP”.
SP-24 Serial Num-
ber Log Press and release the right arrow until “SP-24 S/N ✓EDIT” flashes in
the displays, along with the serial number of the unit.
NOTE: This serial number should match the serial number on the da-
ta plate, on the doors. If not, it can be recorded.
SP-25 Program
Code Change This allows the operator to change the program code (factory set at 1,
2, 3) used to access Product Programming and Level 2 Program
Mode.
Press and release the right arrow until “SP-25 CHANGE MGR
CODE? 1=YES” flashes in the display. Press product 1 and “ENTER
NEW CODE” “P=DONE” “I=QUIT” scrolls through the display. Press
the product buttons for new code. If satisfied with the code, press the
program button and “REPEAT NEW CODE” “P=DONE” “I=QUIT”
shows in display. Enter the same code you previously entered. If sat-
isfied with code, press the program button and “CODE CHANGED*”
shows in display. If not satisfied with code, press the info button and
“*CANCEL*” shows in display, then reverts back to “SP-25”
“CHANGE MGR CODE? 1=YES”. Now the above steps can be
repeated.
SP-26 Usage Code
Change This allows the operator to change the reset usage code (factory set
at 1, 2, 3) to reset the usage amounts of each product. See
4.5
5. Re-
view Usage
, page 52 in Chapter 4
Information Mode
, page 49 .
Press and release the right arrow until “SP-26 CHANGE USAGE
CODE? 1=YES” flashes in the display. Press product 1 and “ENTER
NEW CODE” “P=DONE” “I=QUIT” scrolls through display. Press
product buttons for new code. If satisfied with code, press the pro-
gram button and “REPEAT NEW CODE” “P=DONE” “I=QUIT” shows
in the display. Enter the previously entered code. If satisfied with
code, press the program button, “*CODE CHANGED*” shows in dis-
play. If not satisfied with code, press the info button and “*CANCEL*”
shows in display the reverts back to “SP-26” “CHANGE USAGE
CODE? 1=YES”. Now the above steps can be repeated.