Henny Penny OFG-390, Operator'S Manual

Page: 38 / 51

Model OFG- 390
3-15. PROGRAMMING 1. Press and hold the FUNCTION button for two seconds.
“REG PROGRAM” shows in the display, followed by
“CODE”.
2. Press the code 1,2,3, “SELECT PRODUCT” scrolls
across the display.
If no buttons are pressed, within approximately 1 minute
while in the Program Mode, the controls will revert back
to the Cook Mode.
3. Press the appropriate product button, (1-0), to identify
what product you want to program.
4. “INT1” and “TIME” flashes on the left side of the display.
The right side will show the starting time of the Cook Cycle
and can be changed by pressing the appropriate numbers. Ex:
Press 1,0,0,0 and 10:00 flashes on the right side of the
display, setting the start time at 10 minutes.
5. After the time is set, press and release the FUNCTION
button and “INT1” and “TEMP” flashes on the left side of the
display. The right side will show the starting temperature and
can be changed by pressing the appropriate numbers. Ex:
Press 2,5,0 and “250° F” will show on the right side of the
display, setting the start temperature at 250° Fahrenheit.
6. After the temperature is set, press and release the
FUNCTION button and “INT1”, “LOAD”, and “COMP.”
flashes on the left side of the display. The factory preset
load compensation value shows in the right side of the display.
7. After the load compensation, press and release the FUNC-
TION button. “PROP” and “CONTROL” shows on the
left side of the display and the factory preset proportional
control temperature shows on the right side of the display.
3-16 703