6 Operation
The vacuum packaging machine is equipped with the 10-Program Control System.
•
All persons responsible for the operation of this machine must at least fully read and
understand the chapters Safety on page 10 and Operation on page 23.
•
Failure to follow or disregard of the safety instructions may result in serious injury.
6.1 10-Program Control System (10-PCS)
6.1.1 Operating Elements
The 10-program control system allows the machine to be operated and programmes to be
changed.
Figure 4: Control Panel of the 10-Program Control System
1.
Program display
Shows the selected program.
2.
PROG 0 – 9 button
This is used to select the desired program.
3.
REPROG button
This is used to enable the programming mode. The parameters can be changed using the
Cursor key, the – / STOP button and the + / VACUUM STOP button.
4.
Cursor key
This key is used to operate the functions of the parameter display and function display.
5.
Pump cleaning program button
This is used to activate the pump cleaning program. Moisture can be absorbed by the oil
when the pump is running only short cycles or when you are packaging moisture-containing
products. This program removes moisture from the oil of the vacuum pump. See Running the
Pump Cleaning Program on page 61 for instructions.
Operation 23